2 replies to this topic

[noel]

hi i have asked this before but will try again as i have till spring to get it rite
i have a 90 se that i have modded i rewired the 2 computers to get mas & the other computer to keep the cruise,well the cruise worked but was hunting so bad that i just unplugged the cruise on it & have made up my mind to change the cruise to (manual) but i dont know what i have to change
i also have a 94 mustang for a parts car
any help on the would be appreciated as i really need the cruise when driving for any time
thx noel

[W.V. Kelly]

You could try the electronic speed control system that's on the later cars (mid 90s +). It uses a servo motor instead of vacuum and is capable of one MPH increment changes. Tap ACCEL once and speed increases by one MPH, etc. We have one I hope to install in "Old Blue" before the next ORR event. It works independent of any ECU inputs and takes speed signals from either the transmission output or the differential sensor ('94 F-150). I haven't checked the control resistances yet but if they're different from the M7 controls an outboard panel is not hard to make.
Good luck,
W. V. Kelly

[noel]

W.V. Kelly, on 16 November 2011 - 11:09 PM, said:

You could try the electronic speed control system that's on the later cars (mid 90s +). It uses a servo motor instead of vacuum and is capable of one MPH increment changes. Tap ACCEL once and speed increases by one MPH, etc. We have one I hope to install in "Old Blue" before the next ORR event. It works independent of any ECU inputs and takes speed signals from either the transmission output or the differential sensor ('94 F-150). I haven't checked the control resistances yet but if they're different from the M7 controls an outboard panel is not hard to make.
Good luck,
W. V. Kelly

how do the 85 marks work ?? any how as i said i have an 94 mustang for parts, my main Q is what do i need to change ??????
also i would like to change my steering wheel to the sn95 style, i have seen this done on other marks but dont know if i have to change the clock spring as well or just the wheel ???????